Pattern Imprinted Concrete Walls

Categories:Uncategorized

Precast concrete walls have many uses; you can use them in a kitchen, for bathroom walls or to form a concrete living room in the basement or other home level. Precast concrete is not only used in residential applications but is common in commercial construction as well. Many manufacturers will not allow anyone but their own trained employees install their products, however here are the basics on how they are installed and what is involved in ordering and pre-planning.

Step One: Planning

It important to plan ahead when using precast concrete walls. You need to have the plans for the building and allow for any window and door openings. Once you have the plans ready submit them to the manufacturer to start the process.

Step Two: City Permits

It is important to get the appropriate permits before installing the precast walls. Some cities might require a different base than the minimum gravel base while others may have a minimum thickness requirement for walls. Submit the plans to the city and obtain the proper permits for installing the walls, including the use of a crane.

Step Three: Gravel Base

For a proper base you will need to have 8 to 12 inches of compacted gravel base beneath each wall. It is not necessary to have a concrete base for the precast concrete walls.

Step Four: The Crane

The walls will require use of a crane to lift the precast walls off of the delivery truck and into the correct spot for installation. You need to arrange for a crane, and crane access to the construction site. Be sure to check with your city to see if permits are needed for the crane usage.

Step Five: First Wall

Use the crane and set the first wall into place. This wall will need to be braced with 2 by 4′s  on either side to keep it upright and vertical.

Step Six: Next Walls

The next wall should form a 90 degree angle to the first and will make it possible to remove the braces. The manufacturer builds in pre set holes that will fit together and allow for bolts to hold them in place. Each wall will fit together exactly as your plans specified to the manufacturer.

Comments are closed.

© Copyright - DCS
Ribbon Maker